Showing posts with label CAT-5 video 100M. Show all posts
Showing posts with label CAT-5 video 100M. Show all posts

Tuesday, December 13, 2011

Distributing Video Over CAT 5 and CAT 7

Some SI Need to Know About Video Distribution Through Cat5 or Cat7


When thinking of setting up your home video system, it means that you should know something about distributing video over CAT5 and CAT7 because it is the kind of system that will broadcast optimum performance. It also means that you can now have your source from a distance away from the display device, television or monitor.
There are three (3) general types of video distribution system:
1) Analog or Baseband
2) Internet Protocol
3) Radio Frequency

Any of these types may use coaxial cables, category 5 or more commonly known as CAT5 cables, CAT5e, CAT6, CAT6e or CAT7 cables. What are the differences between them?
1) CAT-5 distributes video up to 100M.
2) CAT-5e 350M.
3) CAT-6 and CAT6e distributes video as far as 550M to 1000M
4) CAT-7 is rated from 700M to 1000M.

Viewing Video Over CAT5 or CAT7
Video over CAT5 or CAT7 like those delivered by CATV, data, and telephone are all distributed in similar wiring closets. It delivers videos that may run along a distance of 100M for CAT 5 or even up to 1000M for CAT7. Video over CAT5 or CAT7 all goes out on the same cabling system. The system is channeled in a passive broadband balun that converts any uneven coaxial signal into a balanced signal through the video over CAT5 or CAT7. Even when distributed to different channels simultaneously, it will not slow down the network because the air analog signals do not travel on that similar network, and thus, it does not rely on the bandwidth of the video signals.
Presently, the use of FTP or UTP cables for audio and video needs is prevalent. Instead of using coaxial cables, CAT5 and CAT7 cables are used. Coax are first installed into the hubs and everything else is distributed through the FTP/UTP. Video over CAT7 or CAT5 for that matter are now possible at a limited cost. There is ease in the installation and location change is not a big deal. All one needs to do is connect patch cords from the distribution hub to the patch panel and have a single port converter connected to the television.

Advantages of a Video System Using CAT5 and CAT7
1) Video over CAT5 or CAT7 is cost effective as it eliminates the need for additional coaxial cables.
2) Configuration of video over CAT5 or CAT7 is much easier than having multiple splitter taps, amplifiers and combiners of coax.
3) A high quality signal is maintained as the distribution system of video over CAT5 or video over CAT7 uses active RF video hubs. It makes automatic slope adjustments hence all video channels’ image quality is sustained.
4) The video distribution system of CAT5 or CAT7 can carry out voice and auxiliary signals simultaneously. There are no interferences between the voice and video data.
5) A system with video over CAT5 or CAT7 allows video streaming from the computer and it is made possible through a broadband video system.
Distributing video over CAT5 and CAT7 is made possible through an RF broadband system. It broadcasts CATV, HDTV, internally generated video, video-on-demand services, and satellite videos through twisted pairs of CAT5 or CAT7 cables.

Tuesday, August 31, 2010

Copper cable wiring from CAT-5 to CAT-7

For several years, the standard cable used for home theater systems and computer networking with copper wire continues to be CAT-5 wiring. It is now dealing with the purpose of being considered old-fashioned, with a brand new standard emerging of CAT-6. Where on earth does that leave CAT-7? Basically, it is as leading edge as you can get within the field. From old to new, CAT-5 to CAT-7. What are the differences and similarities? Let’s take a closer look.


The Simple Answer: 
CAT-5 is rated to 100M 
CAT-5e is rated to 350M 
CAT-6 and CAT6e is rated to 550M or 1000M depending on your source 
CAT-7 is supposedly rated to 700M or presumably 1000M


If you’re establishing a home theater system, CAT-7 and CAT-5 wiring will offer similar benefits. There are obviously a few differences, however–something to be expected because of the newness of CAT-7. Either of these two, however, will work for the one who wants good quality sound.

In lots of homes throughout the nation, the old-fashioned TV room continues to be substituted with the house theater. The TV and audio system are set up so the family can have maximum enjoyment from their movies, sports, and favorite Television shows. To properly install your home theater system, you need to understand what it is set up–which means you need to know how to have it correctly wired.


There are a few possibilities for you for wiring you home entertainment system. Because we’re concerned with CAT-5 and CAT-7 here, we’ll only discuss those which involve those cables. The benefits for either of these is that they’ll offer optimum system performance, plus you can keep your video source at a long way out of your television, monitor or other output device.

You can use your CAT-5 and CAT-7 wiring with three types of distribution systems: Ip address (or IP, distributed via a USB port), RF and Analog. You can use CAT-5 and CAT-7 coax cables for any of those distribution systems. For the purposes, the real difference between CAT-5 and 7 may be the distance that you could run the cable but still achieve optimum results. You can run CAT-5 coax cables up to 100 meters from the output device; you are able to run CAT-7 as much as 1000 meters away.

Both CAT-5 and CAT-7 may be used to deliver video for cable TV (sometimes with a CATV amplifier), Internet data and telephone. Many of these are distributed through similar cabinets. CAT-5 and CAT-7 delivers video for example CATV , telephone, and data. All these is shipped via similar cabinets. There are many advantages for using CAT-5 or 7. Price is one of the main ones; the video for either of these standards is affordable and price efficient. That is because the cable eliminates your need for purchasing extra coax cables. It is also simpler to configure the video than it could be should you have had several splitter amplifiers and taps and coaxial combiners. The body will maintain a superior signal quality, because video distribution via CAT-5 or CAT-7 utilizes active RF video hubs.


When you are deciding how to wire your home video system, just make sure you have carried out your homework in advance, to make sure you are earning the very best choices. You might decide to go with CAT-5 wiring or with CAT-7. Indeed, you may decide to go with some combination of these two. But regardless, make sure you pick what matches with your needs as well as your budget. There are many web sites to find the information you need to determine what’s going to best help you create the ultimate home entertainment experience.